Self-Priming electric pump for various liquids | 12V | Marco 166 020 12

Description Marco 166 020 12,  VP45 Self-priming electric pump for the transfer of liquids of varied nature. The pumping element is made up of acetalic (POM) sliding vanes rotor which can possibly even run dry for brief periods. Equipped with filter on the inlet side. Application Transfer of diesel fuel between tanks, refuelling of tractors and earth moving equipment. Transfer of water. Transfer of antifreeze. Connection Options Fluids Allowed / Not Allowed There are numerous fields of applications for the pump, however only exclusively with the allowed liquids mentioned: Fluids Allowed Fresh Water (max 35 °C) Diesel Fuel (Minimum flashpoint (PM): 38 °C) Warranty expiries if max fluid temperature is exceeded  Fluids Not Allowed Petrol (Gasoline) => Danger: Fire / Explosion Flammable Liquids with PM < 38 °C => Danger: Fire / Explosion Liquids with viscosity > 20 cSt => Danger: Motor overheating Corrosive chemical products => Danger: Pump corrosion – Injury to personnel Solvents => Danger: Fire / Explosion – Damage to seals Technical Data Reference: Marco 166 020 12 Voltage: 12V Fuse: (A) 20 Flow rate: l/min 45 Diesel 0,85 kg/l Internal tube Ø 25 mm Amp Draw: (A) 8 A (bypass): 19 Bypass: bar 1,2 (max 3 min) Self priming: (m) 2 Weight: 1 kg Wire size: (mm2) 1,5 Length up to 2 m Type: Marco VP45 IP 67: Code, International Protection Marking. Dust tight: No ingress of dust; complete protection against contact (dust tight) Immersion up to 1 m: Ingress of water in harmful quantity shall not be possible when the enclosure is immersed in water under defined conditions of pressure and time (up to 1 m of submersion). Ingress Protection code documentation Vane Pumps Self-priming electric vane pumps with integrated by-pass valve. Vanes guarantee high flow rate and heavy-duty cycles. Aluminum body, two connection options. Rotor and vanes made of resin. Stainless steel shaft. FKM seals and NBR O-rings. Brush holder with EMI filter. Available also with case and handlefor easy transport, On/Off switch and battery clips. Installation It is recommended that the use of the pump be according to normative safety standards and also as per the precautions listed below.  Preliminary Checks: Check that there has been no damage to the pump during transportation or storage. Both inlet and outlet ports should be carefully cleaned removing possible dust or residual packaging material. Verify that the available electrical power supply corresponds to the specification requirements  Positioning: The pump can be mounted in any position. Fix the pump utilizing suitable diameter screws corresponding to the holes. Dimensions Exploded View 1. Pump Body 2. Rod 3. Armature 4. Rubber lip seal 5. Washer 6. Ball bearing 7. Pump frame 8. O-ring 9. Brush holder 10. Compensation spring 11. Ball Bearing 12. O-ring 13. Washer 14. Nut 15. Rotor 16. Vane 17. O-ring 18. Top plate 19. Screw 20. Tube Outlet 21. O-ring 22. Cap 23. Antivibration Mount 24. Antivibration insert.   Flow Rate diagram Ampere Draw Diagram About MARCO MARCO manufacture electric and air horns for cars, trucks and boats, as well as electric pumps for the transfer of various liquids. These products are manufactured using the most advanced production equipment, such as spectrum analysers, vibrating stands, and other sophisticated instrumentation, including an anechoic chamber, for the development and testing of products. Today the use of advanced technology enables MARCO to reach the highest International Quality Standards, allowing the creation of highly competitive products that are exported daily to over 80 countries.