Self-Priming electric pump for various liquids | 12V | Marco 164 002 12

Description Marco 164 002 12, UP3-P Self-priming electric pump for the transfer of liquids of varied nature. The pumping elements are made up of bronze gears which can possibly even run dry for brief periods. Equipped with in-line filter on the inlet side. Applications Transfer of water Bilge water discharge Transfer of antifreeze Fluids Allowed / Not Allowed There are numerous fields of applications for the pump, however only exclusively with the allowed liquids mentioned: Fluids Allowed Fresh Water (max 40°C) Diesel Fuel (Minimum flashpoint (PM): 38 °C) Warranty expiries if max fluid temperature is exceeded  Fluids Not Allowed Petrol (Gasoline) => Danger: Fire / Explosion Flammable Liquids with PM < 38 °C => Danger: Fire / Explosion Liquids with viscosity > 20 cSt => Danger: Motor overheating Corrosive chemical products => Danger: Pump corrosion – Injury to personnel Solvents => Danger: Fire / Explosion – Damage to seals ISO 8846 Compliant Device Technical Data: Reference: Marco 164 002 12 Marco UP3-P Voltage: 12V Fuse: A 10 Flow rate: l/min 15 Internal tube Ø 13 mm Pressure: bar 2 Weight: 1,4 kg Wire size: (mm2) 1,5 Length up to 2 m Type: UP3-P IP 67: Code, International Protection Marking. Dust tight: No ingress of dust; complete protection against contact (dust tight) Immersion up to 1 m: Ingress of water in harmful quantity shall not be possible when the enclosure is immersed in water under defined conditions of pressure and time (up to 1 m of submersion). Ingress Protection code documentation PTFE Gear Pumps Self priming electric pumps with helical PTFE gears for the transfer of water and liquids with low viscosity. The PTFE gears guarantee constant pressure, heavy-duty cycles, lower noise levels and excellent resistance to chemicals. Available in versions with in-line filter, integrated check valve, mechanical pressure switch, electronic pressure sensor and kits for various applications. Nickel-plated brass body, stainless steel shaft and FKM seal unless otherwise specified. Installation It is recommended that the use of the pump be according to normative safety standards and also as per the precautions listed below.  Preliminary Checks: Check that there has been no damage to the pump during transportation or storage. Both inlet and outlet ports should be carefully cleaned removing possible dust or residual packaging material. Verify that the available electrical power supply corresponds to the specification requirements  Positioning: The pump can be mounted in any position. Fix the pump utilizing suitable diameter screws corresponding to the holes. Dimensions Exploded View Diagram 1. Pump body 2. O-ring 3. Rod 4. Pump frame 5. Armature 6. Brush holder 7. O-ring 8. Washer 9. Nut 10. Key 11. Idle gear 12. Driving gear 13. O-ring 14. Top Plate 15. Screw 16. Tube outlet 17. O-ring 18. Nipple 19. Filter 20. Antivibration mount. Flow Rate Diagram Ampere Draw diagram About MARCO MARCO manufacture electric and air horns for cars, trucks and boats, as well as electric pumps for the transfer of various liquids. These products are manufactured using the most advanced production equipment, such as spectrum analysers, vibrating stands, and other sophisticated instrumentation, including an anechoic chamber, for the development and testing of products. Today the use of advanced technology enables MARCO to reach the highest International Quality Standards, allowing the creation of highly competitive products that are exported daily to over 80 countries.