Self-Priming Electric Pump For Various Liquids | 12V | Marco 164 620 12

Description Marco 164 620 12, UP6/A Self-priming electric gear pump equipped with filter, pressure switch and non-return valve to be used as automatic pump for water pressure systems. Brass body, PTFE gears, stainless steel shaft and rubber lip seal. The pressure switch is set in the factory between 1 and 2 bar. Application Main use as automatic pump for freshwater and sanitary water systems on boats, camper. Fluids Allowed / Not Allowed There are numerous fields of applications for the pump, however only exclusively with the allowed liquids mentioned: Fluids Allowed Fresh Water (max 40 °C) Warranty expiries if max fluid temperature is exceeded  Fluids Not Allowed Petrol (Gasoline) => Danger: Fire / Explosion Flammable Liquids with PM < 38 °C => Danger: Fire / Explosion Liquids with viscosity > 20 cSt => Danger: Motor overheating Corrosive chemical products => Danger: Pump corrosion – Injury to personnel Solvents => Danger: Fire / Explosion – Damage to seals Technical data: Reference: Marco 164 620 12 Voltage: 12V Fuse: (A) 15 Flow rate: l/min 26 Internal tube Ø 16 mm Pressure: bar 2 Weight: 4 kg Wire size: (mm2) 2,5 Length up to 2 m Type: UP6/A IP 44: Code, International Protection Marking Installation It is recommended that the use of the pump be according to normative safety standards and also as per the precautions listed below.  Preliminary Checks: Check that there has been no damage to the pump during transportation or storage. Both inlet and outlet ports should be carefully cleaned removing possible dust or residual packaging material. Verify that the available electrical power supply corresponds to the specification requirements  Positioning: The pump can be mounted in any position. Fix the pump utilizing suitable diameter screws corresponding to the holes. Dimensions Exploded View Diagram 1. Pump body 2. O-ring 3. Rod 4. Pump frame 5. Armature 6. Brush holder 7. O-ring 8. Washer 9. Nut 10. Idle gear 11. Key 12. Driving gear 13. O-ring 14. Top plate 15. Screw 16. Nipple 17. O-ring 18. Non return valve 19. Air vent valve 20. Nipple 21. Pressure switch 22. Pressure gauge 23. Nipple 24. Tube outlet 25. Filter 26. Antivibration mount Flow Rate Diagram Ampere Draw Diagram   About MARCO MARCO manufacture electric and air horns for cars, trucks and boats, as well as electric pumps for the transfer of various liquids. These products are manufactured using the most advanced production equipment, such as spectrum analysers, vibrating stands, and other sophisticated instrumentation, including an anechoic chamber, for the development and testing of products. Today the use of advanced technology enables MARCO to reach the highest International Quality Standards, allowing the creation of highly competitive products that are exported daily to over 80 countries.