MAGNUM PRO M-10 Hydraulic Calibration Hand Pump Magnum Pro Calibration Pumps, the manufacturer of the MAGNUM PRO M-10, is based in New York, USA. Magnum Pro has rapidly become the calibration pump of choice. Their calibration pumps are currently used in over one third of all power plants. The calibration pumps are virtually indestructible and are the only pumps in the industry backed by a two year warranty. MAGNUM PRO M-10 Specifications: 0 – 10,000 PSI (700 Bar) Compatible with most hydraulic fluids, oils and water Connections (2 ports) 1/4″ NPT/BSP Weight – 3 lbs Made in the USA MAGNUM PRO M-10 Features: Contoured cushion handles Patented protective cage around vent knob Priming feature Patented triple filtration (prevents pump failure caused by dirt) A non-oil based lubricant is used on all moving parts Built in pressure relief valve (prevents over pressurizing) Shatter proof reservoir Oversized check valves for smooth controlled operation 2 year warranty Points to Remember: Do not exceed maximum pressure of 10,000 psi (700 bar). In order to use NPT fittings, the required NPT to BSP Parallel thread adapters need to be installed (adapters included). Do not use thread sealant paste or tape on the male adapters {Paste or tape may be used on female adapters). Bonded washers (included) are required to insure a proper seal. To seal the adapters, simply hand-tighten and snug up with a wrench. Do not over-tighten. Use with distilled water or mineral-based hydraulic oil.
