BMW 2-pin Gray Sealed Receptacle, E36 Low Beam Connector Kit

It is common to run aftermarket lights on a race car due to being cheaper, lighter, and/or higher output. Typically your only option is to cut off the stock connector and splice in the new light. Depending on the new light you use it may not have a connector which would result in the light being directly connected to your wire harness unless you add some other connector between the wire harness and light. Rather than dealing with that and cutting the stock connector you can simply use the mating connector for the stock connector, therefore allowing your new lights to just plug in and also allowing you to revert back to the stock lights. BMW 2-pin Gray Sealed Receptacle, E36 Low Beam Connector Kit Contents: 2x – Gray Receptacles 2x – Blue Lock 5x – Pins for 1.50 – 3.00mm² (1 spare) 5x – Seals for 2.03 – 2.85mm  insulation diameter (1 spare) BMW 2-pin Gray Sealed Receptacle, E36 Low Beam Pigtail Kit Contents: A pair of connectors fully assembled with 1.50mm² FLRYW, approximately 300mm (12″) long. Application List: (partial, compare your connector to others listed here) BMW E36 Low Beams BMW E39 Low Beams (Xenon) BMW E39 Fog Lights (M-Technik) BMW E46 Low Beams (all) BMW E46 Fog Lights (Standard) BMW E90 / E91 Fog Lights (Sport Package) BMW E60 / E61 Fog Lights BMW E63 / E64 Fog Lights BMW X3 E53 Low Beams (Xenon) BMW X3 E83 Fog Lights BMW X5 E70 Fog Lights BMW Z4 E85 / E86 Fog Lights Notes: – Although this connector appears different than what is on many BMW models such as the E46, it will properly connect and seal to the stock connectors. – All items within this connector kit are genuine items sourced from authorized distributors.